Data Sheet

©
RFbeam Microwave GmbH | Schuppisstrasse 7 | CH-9016 St. Gallen | www.rfbeam.ch | K-LD 2 | data sheet 02 / 2020 Revision C | Page 5 / 25
This diagram shows module sensitivity (output voltage)
in both azimuth and elevation directions. It incorporates
the transmitter and receiver antenna characteristics.
-70
-60
-50
-40
-30
-20
-10
0
350°
340°
330°
320°
310°
300°
290°
280°
270°
260°
250°
240°
230°
220°
210°
200°
190°
180°
170°
160°
150°
140°
130°
120°
110°
100°
90°
80°
70°
60°
50°
40°
30°
20°
10°
System diagram
Azimuth Elevation
80°
34°
Pin No. Name Description
1 GND Ground pin
2 Detect Out Digital detection output.
Signalsa valid detection.
Low " no detection
High " valid detection
3 VCC Power supply pin (3.2 to 5.5V)
4 RX Serial interface RX input
5 TX Serial interface TX output
6 Hold Time In Analogue hold time input. Rangefrom0to3V
0V " minimum hold time
3V " maximum hold time
7 Sensitivity In Analogue sensitivity input.
Range from 0 to 3V
0 V " minimum sensitivity
3V " maximum sensitivity
8 Misc. Out Digital miscellaneous output. The function
isprogrammable over the command set with
the parameter S06.
In the factory setting this output signals the
direction ofavalid detection.
Low " backward / receding movement
High " forward / approaching move ment
This output is only valid toge ther with a
high on pin2 (valid detection) except if it
isconfigured as micro detec tion output.
Table 1: Pin function description
25.00 ±0.1
25.00 ±0.1
20.20 ±0.1
20.20 ±0.1
3.90
2.40
3.61
7x2.54
1.60
Pin 1
0.75 ±0.1
2.55 ±0.15
8.64 ±0.25
6.00 ±0.1
2.30 ±0.15
Pin 1
D
C
B
6
5
4
3
2
1
A
2
1
4
3 5
B
A
C
Plotdate: 31.05.2017
We reserve all rights in this document and its subject matter.
The recipient herby acknowledges these rights and assures the use of this
document only for the purpose it was delivered. © RFbeam Microwave
Dieses Dokument ist unser geistiges Eigentum. Es darf ohne unsere ausdrückliche Genehmigung
weder kopiert, vervielfältigt oder verwertet, noch an Dritte weitergegeben werden. Zuwiderhandlung
ist strafbar und wird strafrechtlich verfolgt. Copyright reserved! © RFbeam Microwave
Drawing Nr.
A4
1 / 1
Blatt / Anz.
Project
Scale
2:1
Material
Tolerance
Format
Prepared
Reviewed
Object
Surface
RFbeam Microwave
Farbgutstrasse 3
9008 St. Gallen
Switzerland
State
Index
XX
YY
XX
YY
Figure 3: Pin configuration
Figure 2: Antenna characteristics
PIN CONFIGURATION AND FUNCTIONS
ANTENNA DIAGRAM CHARACTERISTICS