Data Sheet

Schuppisstrasse 7

CH-9016 St. Gallen

www.rfbeam.ch

K-LC5

data sheet 03/2021 – Revision G

Page 6 / 9

INTEGRATORS INFORMATION

Installation Instruction

Mechanical enclosure

It is possible to hide the sensor behind a so called

radome (short for radar dome) to protect it from

environmental inﬂuences or to simply integrate it in

the case of the end product. A radar sensor can

see trough different types of plastic and glass of any

colour as long as it is not metallized. This allows for a

very ﬂexible design of the housing as long as the rules

below are observed.

– Cover must not be metallic.

– No plastic coating with colors containing metallic or

carbon particles.

– Distance between cover and front of Radar sensor

should be >= 6.2mm

– Cover thickness is very important and depends on

the used material. Examples can be found in the

application note „AN-03-Radome“.

– Vibrations of the Radar antenna relatively to the

cover should be avoided, because this generates

signals that can trigger the output

– The cover material can act as a lens and focus or

disperse the transmitted waves. Use a constant

material thickness within the area used for trans-

mission to minimize the effect of the radome to the

radiated antenna pattern.

Detailed information about the calculati-

on and thickness for different cover mate-

rials can be found in the application note

“AN-03-Radome”.