User's Manual

___________________________________________________________________________
RF Technology T800 Page 11
3 TRANSMITTER I/O CONNECTIONS 3.2 Rear Panel Connectors
3.2 Rear Panel Connectors
The exciter and receiver can be supplied with optional rear panel connectors that bring
out the more important signals available on P1, the rear panel DB25 connector.
Figures 1 and 2 show the rear panel connectors, and Table 4 shows the signals that are brought
out to the spade connectors. The spade connectors (2.1x0.6x7mm) are captive/soldered
at the labelled points.
Fig 1 Fig 2
RX PCB TX PCB
The Receiver and Transmitter modules plug into the back plane DB25/F connectors
To configure: Solder wire connections between appropriate points.