Technical data

9
150
Manual – Gear Units and Gearmotors
Important order information
Mounting Positions and Important Order Information
9.2 Important order information
The following
applies to all gear
units and gear-
motors
Observe the following notes for all gear units, gearmotors and MOVIMOT
®
gearmotors
from SEW-EURODRIVE.
Direction of
rotation of the
output with a back-
stop
If the drive has a backstop RS, you have to indicate the direction of rotation of the output
for the drive. The following definition applies:
In right-angle gear units, you also have to indicate whether the direction of rotation is
given looking onto the A or B end.
Position of the
output shaft and
output flange
In right-angle gear units, you also have to indicate the position of the output shaft and
the output flange:
• A or B or AB (→ Figure 84)
The following order information is required for R, F, K and S gear units and gearmotors
in addition to the mounting position to exactly determine the design of the drive.
This information is also required for Spiroplan
®
gearmotors (W gearmotors) that do not
depend on a particular mounting position.
As viewed at the output shaft:
Clockwise (CW) = Rotating clockwise
Counterclockwise (CCW)= Rotating counterclockwise
57504AXX
Figure 83: Direction of rotation of output
A
B
CCW
CW
CCW
CW
57505AXX
Figure 84: Position of the output shaft and the output flange
A
B
M1…M6M1 … M6