User manual

RF Technology WinTekHelp User Manual Page 6
2. Setting Up WinTekHelp User Manual
Run WinTekHelp (See Section 1). WinTekHelp defaults to a serial baud rate of 57600 bits per second, with no
parity, and to the serial port chosen in the installation procedure (See Section 1). Each Receiver and Exciter is
factory configured to run at 57600 bps and with no parity. WinTekHelp, from version 1.4, will try the default
COMM port, at the default speed, first, but if it cannot find an exciter or receiver, it will try various baud rates
and COMM ports until it can find an exciter or receiver. If everything has been connected correctly, then you
should see a dialog box on your computer screen that looks like Fig 1, if the attached unit is an exciter, or like
Fig 2 if it is a receiver.
If there is some problem with communications, you will see a dialog box like Fig 3.
Fig 1
Fig 2