User manual

RF Technology WinTekHelp User Manual Page 19
WinTekHelp User Manual 3.2 Edit/Examine Channel Data
3.2 Edit/Examine Channel Data
Click on this button in the Main Menu to examine and/or modify the channel data for the receiver or exciter.
After clicking on this button, WinTekHelp will upload the existing channel data from the receiver or exciter.
Whilst this occurs a Progress bar is displayed. When that is complete, a dialogue box as shown in Fig 11 will
open.
This dialog box can also be accessed from the dialog box shown in Fig 3, which is invoked if no receiver or
exciter is detected. In this case the “Save Data to Flash Memory” button will be “greyed out”, and there will not
be an attempt to read any existing data from a receiver, or an exciter.
By clicking on the “Read Channel Data from a file” button, the channel data read from the receiver or exciter can
be overwritten with channel data from a file. If the unit is connected to a receiver, WinTekHelp will look for
files ending in “.r50” If it is connected to an exciter, it will look for files ending in “.t50”. If there is no receiver
or exciter connected, it will look for files that end in either of these extensions. If one selects a file ending in
“.r50”, WinTekHelp will assume that receiver channel data is to be examined or edited. If one selects a file
ending in “.t50”, then WinTekHelp assumes that data for an exciter is to be examined or edited.
After one has edited the channel data, one can save that data in one or more of three different ways. The data
Fig. 10
Fig 11