User's Manual

Eclipse2 Technical Manual, 3-Aug-12 Page 2 of 17

List of Associated Publications

Document Nu

Description

TPR-0308920019 IP Commander User Manual

Disclaimer

Due t

o our policy of continuous improvement of our products and services, technical specifications and

claims that were correct at time going to print maybe subject to variation without notice. RF Technology has

endeavoured to ensure that the information in this document is correct, but does not accept liability due to

typographical, omissions or other errors or subsequent modifications of the product.

Specifications may vary from those given in this document in accordance with the requirements of local

regulatory authorities.

All information contained in this manual is the property of RF Technology Pty Ltd.

All rights are reserved. This manual may not, in whole or in part, be copied, photocopied, reproduced,

translated, stored, or reduced in any manner without prior written permission.

All trade names referenced are the trademarks or registered trademarks of the respective manufacturers.

Users are cautioned that changes or modifications not expressly approved by RF Technologies

could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

RF Technology Pty Limited

Unit 46 / 7 Sefton Road

Thornleigh NSW 2120

Sydney Australia

Phone +61 2 9484 1022

Fax +61 2 9484 1288

Web www.rftechnology.com.au