User's Manual

Eclipse2 Technical Manual, 3-Aug-12 Page 16 of 17
Channel Programming
The channel information is stored in Flash memory and can be programmed via the Ethernet, USB
o
r
R
S232 interface using a Host PC and RF Technology’s Service Kit software.
Channel Selection
Channel can be select by Service Kit or front panel buttons (if enabled).
Physical Configuration
The transceiver is designed to fit in a 19-inch rack mounted frame. The installed height is 4 RU
(178 mm) and the depth 350 mm. The transceiver is 63.5 mm. The weight of the transceiver is
approximately 1.6kg
Connectors
Antenna Connector
Receiver: Type N 50ohm Female Mounted on the module rear panel
Exc
iter: SMA or Optional N Type 50ohm Female Mounted on the module rear panel.
Power & I/O Connector
25-pin “D” Male Mounted on the rear panel
Ethernet Connector
LED Embedded RJ45 Mounted on the rear panel
E/M Line Connector
RJ45 Mounted on the rear panel
RS232 & External Reference Connector
9-pin “D” Female mounted on the front panel
Microphone connector
RJ45 Mounted on the front panel
USB
Type A female Mounted on the front panel.