User's Manual

ECLIPSE2 IPCommander User Manual

The output of each function block can be connected to the inputs of multiple function

blocks, to a maximum of ten. To do this, repeat the dragging operation, from the small red

square, for each desired output connection. Under these circumstances, the input to each

block is identical, the single output being simultaneously copied to each of the function

block inputs.

Signal Maps can also be saved to a file and reused to configure another base station. To

save a configuration click the “Save As” button and type a filename name and click “Save”. If

a configuration does not fit within the signal map window, use the Zoom Out or Zoom In

buttons to resize the window so that all the function blocks are visible. Should the

configuration be no longer visible, click the Zoom button to reset the Signal Map back to

its default magnification.

Function blocks have fixed properties and variable parameters, such as:

• Input Only

• Output Only

• Multiple Outputs / Multiple Inputs

• Audio Gain or Attenuation (dB)

• Frequency Response

• Priority or Signal Mix

• IP Address and/or Port Number (Unicast or Multicast)

Figure

Signal Map