User's Manual

ECLIPSE2 IPCommander User Manual

5.1. Operational Channel

Displays the current active channel including transmit and receive frequencies.

To change channels click on the “Up” or “Down” arrows on the “Channel” field and click the

“Apply” button.

5.2. Networking

The Networking field displays, and allows the configuration of, the parameters required for

IP networking: the current base station name, IP address, subnet mask and gateway IP.

• Name: Specifies the name of the base station.

• IP: The IP Address of the base station. This is the IP Address to which IP Commander

will connect.

• Mask: The subnet mask of the base station. The subnet mask defines which IP

addresses are to be treated as being inside the LAN, and which are outside the LAN.

• Gate: The gateway IP, or default route, for the base station. A value of “0.0.0.0”

means there is no default route. The gateway IP is the address to which traffic

destined outside the LAN will be sent to.

Changes to these fields require that the base station be rebooted, for the new network

settings to be accepted and to take effect. On pressing the Apply button, the user will be

asked if it is okay to reboot the Eclipse2. If a reboot is declined, the changes will be

Figure

Overview Panel