User's Manual

Page 10 R
F
Technology
4 SPECIFICATIONS 4.2 Physical Configuration
4.2 Physical Configuration
The power amplifier is designed to fit in an RF Technology sub-rack within a 19" rack
frame. The installed height is 4 Rack Units (RU), or 178mm, and the depth is 350mm.
The amplifier is 95.25mm or three Eclipse units wide. The amplifier uses an extruded
aluminum heat sink with vertical fins. Heatsink temperature rise is typically 25C at
100W output.
4.3 Front Panel Indicators and Test Points
4.3.1 Indicators
Power: Green LED
RF Power: Yellow LED
Over Temperature/High Reverse: Red LED
4.3.2 Test Points
No conventional test points (test points available over SNMP).
4.4 Electrical Specifications
4.4.1 Power Requirements
Operating Voltage: 10.5 - 15.2 Volts (output power reduced below 12.5V)
Current Drain: 22 Amperes maximum (20 typical) at 100 Watts and 13.5 Volts, 350mA
maximum standby.
Polarity: Negative Ground
4.4.2 Frequency Range
Model Frequency Range
IP
•
PA500BH 450-520MHz
IP
•
PA500B 450-520MHz
E2-IP-PA 500BH