User's Manual

© RF Technology 2007
PART 2: TRANSCEIVER
2.1 OPERATING BASICS
The transceiver will need approximately 30 seconds to boot up after power up. When
the transceiver is ready to operate, a voice report (if enabled) can be heard from front
panel speaker, and Digital/Analog LED will indicate that the transceiver current working
mode.
2.1.1 Front Panel Controls and Indicators
The front-panel includes LED indicators, tactile switch buttons, a microphone connector
and an USB (type A) connectors, refer figure.1 for details
Status
Up
Test
Left Right
Down Reset
Analog
Microphone Connector
USB Connector Tx
Digital Rx
Power
Alarm
Figure1: Eclipse2 Transceiver Front panel
2.1.1.1 Buttons:
Status – Press this button to listen the voice report
Test – Press this button to key up the exciter (if front panel test key enabled)
Up – Press this button to increase the speaker volume
2