User's Guide

PinPoint 721 Tag and PinPoint Tag Programmer

To test a 721 Tag

1 Enter the 721 Tag into the PinPoint System.

2 Position the 721 Tag within the line of sight of a PinPoint Antenna.

3 Verify that the 721 Tag is read by the system.

For more information about entering a 721 Tag into the PinPoint

System, see the PinPoint Mobile Resource Manager Software User Guide.

After you have applied the 721 Tag to an asset, it is important to test the tag for proper

functionality.

Testing a 721 Tag

Troubleshooting

eussInosaeRnoituloS

gnittimsnarttonsigaT.edompeelsnillitssigatehT

.daedsiyrettaBehT

.PTPehthtiwtidaertsumuoY

ta.cnI,seigolonh

ceTFRtcatnoC

.6499-966)008(

ecruoserehtfoffognillafsigaTdenaelctonsawecafruS

evisehdaehtrofyletairporppa

dap

dna,dapevisehdaehtevomeR

lyporposihtiwylhguorohtnaelc

.lohocla

Replacing a Battery in the PTP

In some cases, it is necessary to replace the 9-volt battery in the PinPoint Tag Programmer.

Use the following steps.

To replace the battery

1 Disconnect the PTP Unit from the PTP Cable.

2 Remove the battery cover from the PTP unit.

3 Remove the 9-volt battery.

4 Replace new 9-volt battery according to directions on the inside of the battery

compartment.

PTP Unit

Battery Compartment

Battery Cover