User's Guide

PinPoint 721 Tag and PinPoint Tag Programmer
PinPoint 721 Tag and PinPoint Tag Programmer
3
Preface................................................................................................................................3
Overview............................................................................................................................4
Using the PinPoint Tag Programmer..............................................................................5
Replacing a Battery in the PTP ......................................................................................8
Applying a 721 Tag .........................................................................................................9
Removing a 721 Tag ......................................................................................................10
Testing a 721 Tag............................................................................................................11
Troubleshooting ..............................................................................................................11
Cleaning and Caring for a 721 Tag...............................................................................13
721 Specifications............................................................................................................14
PTP Specifications............................................................................................................14
WARNINGS
Compliance Statement ( Part 15.19 )
This device complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
Warning ( Part 15.21 )
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
RF Exposure ( OET Bulletin 65 )
To comply with FCC RF exposure requirements for mobile transmitting devices,
this transmitter should only be used or installed at locations where there is at least
20cm separation distance between the antenna and all persons.
FCC ID: OGK30013500001
IC Part # - TAG - 1001 - 05
Industry Canada ID CAN xxxxxxxxxxxxxxxx
Industry Canada Statement
The term “IC” before the certification/registration number only signifies that the
Industry Canada technical specifications were met.
Contents
Copyright 2004 by RF Technologies, Inc.
All rights reserved. No part of this work may be reproduced or copied in any form or by any
means without written permission from RF Technologies, Inc.