PinPoint 721 Tag and PinPoint Tag Programmer User Guide User Guide P/N: 3000-11620-001 Released: 02/26/04 PinPoint 721 Tag and PinPoint Tag Programmer PinPoint 721 Tag and PinPoint Tag Programmer
Contents Preface................................................................................................................................3 Overview............................................................................................................................4 Using the PinPoint Tag Programmer..............................................................................5 Replacing a Battery in the PTP ......................................................................................
NOTES: Important Information It is important for your facility to implement and enforce the following guidelines in order to keep all equipment functioning properly. Installation and Configuration It is the responsibility of the facility to use the supplies specified by RF Technologies for all (PinPoint® ) installations. Failure to use the supplies specified by PinPoint may result in equipment failure.
Preface NOTES: This guide provides detailed information about the PinPoint 721 Tag and the PinPoint Tag Programmer. It provides detailed instructions about using the 721 Tags and Tag Programmer as well as specific requirements. The PinPoint System is a Real-Time Location System (RTLS). It uses high frequency radio signals from cell controllers to locate and follow the movement of the 721 tags, which are attached to assets.
NOTES: Overview The 721 Tag is designed for use in PinPoint RTLS system. It can be used in applications involving the tracking and monitoring of industrial, construction, and hospital equipment in order to improve equipment utilization by providing real-time location information staff can quickly find the equipment when needed. In addition, it provides an historical record of the equipments’ movement histories, allowing for analysis and possible restructuring of internal processes.
Using the PinPoint Tag Programmer When you initially receive the PinPoint 721 Tags, it is necessary to program them before use. To do this, use the PinPoint Tag Programmer software. This reads and programs the 721 Tags and enables them to work with your system. Before you can activate the tags, you must configure the PTP unit to connect to the Comm Port on your computer and install the PTP software on your computer. Use the following steps.
Cleaning and Caring for a 721 Tag This section provides detailed information about cleaning and caring for a 721 Tag. If you want to use a cleaner other than, Isopropyl Alcohol, please contact RF Technologies at (800) 669-9946, To clean a 721 Tag after use To program a 721 Tag NOTE: If you receive a “check sum” error when attempting to read or program a tag, verify that the PTP is at least three feet away from a laptop or computer monitor.
Function Description Tag ID Displays the Tag ID. Stationary Chirp Rate The chirp rate in effect when the asset is stationary. Deep Sleep Mode For use only when 721 Tags are to be stored or shipped. Used to prolong battery life. Motion Sensitivity Identifies how much motion is required to set the sensor. Motion Chirp Rate The chirp rate in effect when the asset is moving. Motion Chirp Count Number of times the 721 Tag transmits the motion chirp rate before returning to stationary rate.
Replacing a Battery in the PTP Testing a 721 Tag After you have applied the 721 Tag to an asset, it is important to test the tag for proper functionality. In some cases, it is necessary to replace the 9-volt battery in the PinPoint Tag Programmer. Use the following steps. To replace the battery To test a 721 Tag 1 Enter the 721 Tag into the PinPoint System. 1 Disconnect the PTP Unit from the PTP Cable. 2 Position the 721 Tag within the line of sight of a PinPoint Antenna.
Removing a 721 Tag Applying a 721 Tag The 721 Tag can be attached using an adhesive pad that can be purchased with the 721 tag. The following section provides detailed steps about applying the 721 Tag using the adhesive. NOTE: Depending on the policies of your facility, you may also use other means of attaching a 721 Tag to your assets. For example, a loop mount zip tie. Adhesive Pad To apply the adhesive pad to the 721 Tag 1 Remove an adhesive pad from the strip of paper.
