Installation Guide

FCC Application for PinPoint – Tag Manual
FCC ID: OGK30011662001
Report No. EA0440-1
22-Mar-00
Page
6 of 6
______________________________________________________________________
Mounting Tags - Personnel Mount
Personnel Mounts are designed to enable a Tag to be worn around the neck or on a pocket.
1.
Attach the ID Clip to the Tag as shown.
2.
Insert the clip plug into the gap behind the clip. Be sure it is snug.
3.
Using the ID Clip, affix the tag to a belt, or if desired, run a lanyard through the ID
badge to wear the Tag as a necklace. Note: The Tag’s logo must always be facing out as
otherwise the wearer’s body will block the Tag’s antenna.
33.Maintaining the Tag
The ViewPoint Administrator software package contains a battery monitoring application, which
will generate a report of all Tags that have a low battery (See the ViewPoint Software Manual
for more information).
To change the Tag’s battery:
1.
If the Tag is mounted to the Asset Mount, remove the Tag from the Mount with the Tag Key.
2.
Detach the battery covers by carefully unscrewing the two (2) battery compartments using
the 2-pin tool.
3.
Turn the Tag upside down to remove the button cell batteries. If necessary, remove the AA
batteries in the asset mount, dispose of properly and replace.
4.
Properly dispose of the old batteries.
34 PinPoint Local Positioning Systems
35
5.
Install the new batteries as shown in the photo. Note: Pay particular attention to the
battery orientation. If you install the battery backwards, the Tag won’t work.
6.
Reinstall the battery covers with the 2-pin tool.
7.
If the Tag is from an asset mount, reattach the Tag to the mount following the
instructions in the Tag Mounting section of this manual.
Technical Specifications
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Frequency:
Tx: 5.80 GHz
Rx: 2.44 GHz
Radiated Power: <0.5mW EIRP
Power Source: (2) 1.5V AgO
2
Batteries
Radiation Pattern: Semi-spherical (from front face of tag)
Dimensions: 2.5” x 1.5” x 0.2”
Environment: 0°C – 50°C (operating range)
Water-resistant
36 PinPoint Local Positioning Systems