Installation Guide
FCC Application for PinPoint – Tag Manual •
••
• FCC ID: OGK30011662001 •
••
• Report No. EA0440-1
22-Mar-00
Page
5 of 6
______________________________________________________________________
4. Connect the SMA connectors of the Coaxial Cable to the Antenna and the Cell Controller,
only after they are both
mounted. Do not overtighten the cable connections (max. 8 inch-lbs.)
25.Technical Specifications
Length: 100 feet
Weight: 2.8 lbs
Temperature: 5°C to 35°C (operating range)
Min. Bend Radius: 0.5”
Fire Rating: Plenum - UL/NEC Rated “ CL2R/CATVR”
Riser – UL/NEC Rated
Shielding: 90dBm
26 PinPoint Local Positioning Systems
Tag Installation and Maintenance
27.Warnings
The 3D-iD Tags are water and shock resistant. However, prolonged immersion, high-pressure
washing, or extreme force can damage the Tags. When installing the Tags, keep in mind that
metallic objects and other radio absorbers and reflectors in the immediate area of a Tag will
hinder its performance. The Tags may be washed with alcohol, diluted bleach, and diluted
ammonia. Harsher solutions may cause damage to the Tag’s exterior or seal. Changes and
modifications not expressly approved by PinPoint Corporation could void the user’s authority
to operate the equipment.
28 PinPoint Local Positioning Systems
Included in the Tag Package
This package may include:
10 or 25 Tags
1 Tag Key
10 or 25 Asset Mount Kits consisting of:
1 Asset mount
2 Hose clamps
1 Rubber Pole Mount
Double-sided Tape
2 AA Batteries
10 or 25 Personnel Mount Kits consisting of:
1 Lanyard
1 ID Clip
1 Clip Plug
29.Mounting Tags - Asset Mount
The asset mount can be used to attach the Tag to any flat surface or curved surface (up to 2”
diameter), such as a narrow bar or a pole.
1.
The Tag is inserted into the mount by placing the bottom of the Tag in the bottom of the
mount and snapping the Tag into place.
2.
Ensure the batteries are inserted the mount as shown.
Mounting to a flat surface
1.
Affix the bottom of the mount to the desired surface using the double-sided tape or screw
the mount to the asset using the three (3) screw holes as shown.
2.
Place the Tag in the mount. Ensure that the logo is facing outwards, so that the mount
does not block the Tag’s antenna.
3.
The Tag and Mount should appear as shown.
30 PinPoint Local Positioning Systems
Mounting to a curved surface
1.
Place the rubber mount between the Asset Mount and the curved surface.
2.
Run the hose clamps through the upper and lower channels of the mount.
Note: Other mechanisms may be used to secure the mount to a curved surface, including tie-
wraps or security banding. Ask your certified 3D-iD system integrator for details.
31.
3.
Attach the mount to the curved surface until the mount is in place.
4.
Place the Tag in the mount as described earlier in this section. Ensure that the logo is
facing outwards so that the mount does not block the Tag’s antenna.
5.
The Tag and Mount should appear as shown.
32 PinPoint Local Positioning Systems