User Manual

Inst alling the Cell Controller
1. Attach the enclosed power cord to the AC outlet on the
Cell Controller. Plug the power cord into the wall outlet.
2. Att ach the appropriate network cable (ethernet) to the
Cell Controller. The ethernet cable should be connected
to the V iewPoint network.
3. Attach up to 16 Antennas (depending upon the system
layout) to the antenna ports using the specified 3D-iD
Coaxial Cables (shipped separately). Att ach the
Antennas where indicated by your certified system inte-
grator.
- Never attach the Antenna cables while the Cell
Controller is powered on! Equipment damage may
result!
- Do not overtighten the coaxial cables!
- Do not kink the coaxial cables!
4. Turn on the Cell Controller using the power switch. The
Cell Controller will enter a mode where it continuously
searches for the server software on the network.
6
Pin Poi nt Local Positioning Systems
Picture of rear of Cell
Controller, with cables.
cc.qxd 5/5/99 4:28 PM Page 6