Installation Guide

Inst alling T ags
Mounting to a curved surface (cont.):
3. Attach the mount to the curved surface and tighten the hose
clamps screws until the hose clamp s run nearly flat along
the channel in the mount.
4. Screw the tag to the mount using the two (2) security
screws and the security screw driver. Ensure that:
- The logo is facing outwards
- The screws are not overtighted (overtightening can
damage the Tag package)
5. The Tag and Mount should appear as shown.
7
tags.qxd 5/5/99 4:27 PM Page 7