Installation Guide

Mounting to a curved surface:
1. Apply the enclosed strip of foam tape down the middle of
the vertical axis on the bottom (flat side) of the Tag
Mount
2. Run the hose clamps through the upper and lower chan-
nels of the mount. The ends of the hose clamps should
meet above the flat side of the mount.
Note: Other mechanisms may be used to secure the
mount to a curved surface, including tie-wraps or securi -
ty banding. Ask your certified system integrator for
det ails.
6
Pin Poi nt Local Positioning Systems
tags.qxd 5/5/99 4:27 PM Page 6