Users Manual
Table Of Contents
- 概述
- 模块参数
- 模块引脚及定义
- PCB封装尺寸
- 布局建议
- 推荐操作条件
- 回流焊条件
- 静电放电警示
- 版本更新记录
- 联系我们
- um warning.pdf
- 1 Overview
- 2 General Specification
- 3 Pin Assignments
- 4 Dimensions
- 6 Host Interface Timing Diagram
- 7 Reference Design
- 8 Ordering Information
- 9 The Key Material List
- 10 Environmental Requirements
- 11 Package
- 警告语
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
The devices must be installed and used in strict accordance with the manufacturer's instructions as described
in the user documentation that comes with the product.
Any company of the host device which install this modular with modular approval should perform the test of
radiated & conducted emission and spurious emission, etc. according to FCC part 15C : 15.247 and 15.209
& 15.207 ,15B Class B requirement, Only if the test result comply with FCC part 15C : 15.247 and 15.209
& 15.207 ,15B Class B requirement,then the host can be sold legally.