Shenzhen RF-star Technology Co.,Ltd. RF-BM-2652P2 Specification Version 1.0 ShenZhen Rfstar Technology Co.
Shenzhen RF-star Technology Co.,Ltd. 目录 ⚫ Overview ............................................................................................................................................... 3 ➢ Brief introduction ..................................................................................................................... 3 ➢ Application ............................................................................................................................... 4 ⚫ Module parameters ......
Shenzhen RF-star Technology Co.,Ltd. ⚫ Overview ➢ Brief introduction RF-BM-2652P2 is a multi-protocol 2.4GHz high transmission power wireless module based on Texas Instruments CC2652P, which is independently developed by ShenZhen Rfstar Technology Co.,Ltd. In addition to integrating a high-performance ARM Cortex-M4F processor responsible for application logic with an ARM Cortex-M0 processor dedicated to the RF core, the module also features a 16-bit low-power sensor processing core.
Shenzhen RF-star Technology Co.,Ltd.
Shenzhen RF-star Technology Co.,Ltd. ⚫ Module parameters Table 1. parameters Chip Working voltage Working frequency Maximum transmitting power Receiving sensitivity CC2652P 1.8 ~ 3.8 V，3. 3V is recommended 2402 MHz ～ 2480 MHz + 20 dBm -100 dBm @ 802.15.4 (2.4 GHz) -105 dBm @ Bluetooth 125-kbps (LE Coded PHY) SRAM 80 KB FLASH 352 KB GPIO Power consumption Encapsulation Interface Size Operating temperature Storage temperature 23 个 The current of receives：6.9 mA The current of transmit：7.
Shenzhen RF-star Technology Co.,Ltd. ⚫ Module size and pin definition UNIT:MM Figure 2. RF-BM-2652P2 size Figure 3.
Shenzhen RF-star Technology Co.,Ltd.
Shenzhen RF-star Technology Co.,Ltd. ⚫ The considerations hardware design ⚫ 1. It is recommended to use a DC regulated power supply to power the module. The ripple coefficient of the power supply should be as small as possible and the module should be reliably grounded. Please pay attention to the correct connection of the positive and negative poles of the power supply, such as the reverse connection may cause permanent damage to the module; ⚫ 2.
FCC Statement FCC standards: FCC CFR Title 47 Part 15 Subpart C Section 15.247 PCB Antenna with antenna gain：0dBi Integral antenna with antenna gain：4dBi This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1 This device may not cause harmful interference, and (2 this device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. The devices must be installed and used in strict accordance with the manufacturer's instructions as described in the user documentation that comes with the product. Any company of the host device which install modular with Limit modular approval should perform the test of radiated & conducted emission and spurious emission,etc. according to FCC part 15C : 15.
