Shenzhen RF-star Technology Co.,Ltd. RF-BM-2652P3 Specification Version 1.0 ShenZhen Rfstar Technology Co.
Shenzhen RF-star Technology Co.,Ltd. 目录 ⚫ Overview ............................................................................................................................................... 3 ➢ Brief introduction ..................................................................................................................... 3 ➢ Application ............................................................................................................................... 4 ⚫ Module parameters ......
Shenzhen RF-star Technology Co.,Ltd. ⚫ Overview ➢ Brief introduction RF-BM-2652P3 is a multi-protocol 2.4GHz high transmission power wireless module based on Texas Instruments CC2652P, which is independently developed by ShenZhen Rfstar Technology Co.,Ltd. In addition to integrating a high-performance ARM Cortex-M4F processor responsible for application logic with an ARM Cortex-M0 processor dedicated to the RF core, the module also features a 16-bit low-power sensor processing core.
Shenzhen RF-star Technology Co.,Ltd.
Shenzhen RF-star Technology Co.,Ltd. ⚫ Module parameters Table 1. parameters Chip Working voltage Working frequency Receiving sensitivity CC2652P 1.8 ~ 3.8 V，3. 3V is recommended 2402 MHz ～ 2480 MHz -100 dBm @ 802.15.4 (2.4 GHz) -105 dBm @ Bluetooth 125-kbps (LE Coded PHY) SRAM 80 KB FLASH 352 KB GPIO Power consumption Encapsulation Interface Size Operating temperature Storage temperature 23 个 The current of receives：6.9 mA The current of transmit：7.3 mA @ 0 dBm 9.
Shenzhen RF-star Technology Co.,Ltd. ⚫ Module size and pin definition UNIT:MM Figure 2. RF-BM-2652P2 尺寸图 Figure 3. RF-BM-2652P2 引脚图 Table 2.
Shenzhen RF-star Technology Co.,Ltd. 5 DIO25 GPIO 6 DIO26 GPIO 7 DIO27 GPIO 8 VCC Supply 9 GND GND 10 DIO7 GPIO 11 TMSC JTAG_TMSC 12 TCKC JTAG_TCKC 13 DIO21 GPIO 14 DIO20 GPIO 15 DIO5 GPIO 16 DIO6 GPIO The supply of module: 1.8V ~ 3.8V, 3.3V is recommended ⚫ The considerations hardware design ⚫ 1. It is recommended to use a DC regulated power supply to power the module.
Shenzhen RF-star Technology Co.,Ltd. ⚫ 6. If there are devices with large electromagnetic interference around the module, it will also greatly affect the performance of the module. According to the intensity of the interference, it is recommended to stay away from the module appropriately. ⚫ 7. Assuming that there are wiring (high-frequency digital, high-frequency analog, power wiring) with large electromagnetic interference around the module, it will also greatly affect the performance of the module.
FCC Statement FCC standards: FCC CFR Title 47 Part 15 Subpart C Section 15.247 PCB antenna , Antenna gain 0dBi This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
—Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
