User's Guide

T01150 - Wireless ECF User Guide.doc

The ‘setup addresses’ list displays unit serial numbers for the RF buttons the currently selected address

(default is 0) and the registered date/time. The registered date and time is updated when ever the

system receives a button serial the list is sorted in order of most recent registered time so that it is

easy to identify which button serial was the last one to be sent.

3.1 Programming a Button Address

When both buttons on a RF button are held down for about 5 seconds the top left LED will go amber.

Releasing the buttons triggers a serial number to be sent to the hub. This serial number will appear in

the list as per the above screen shot. Using the ‘Edit’ option change the ‘Unit Address’ field to the

desired address of the button. Press and hold the buttons on the RF unit again and the system will send

the new address to the button unit. The zone is handled automatically by the system and is set to the

zone number selected under the ‘Hardware Configuration’ options.

3.2 Programming a PDU Address

The PDU addresses are programmed from the ‘Comms Processor’ application.