User manual

RF Neulink NL6000 User Guide
48
• Press ESC twice to return to the Main Menu .
• Select Exit to save the Receive Diagnostic Mode setting and enter
operating mode.
Appendix B - Factory Default Parameters
The following chart lists the default values set for each parameter at the factory. Use
the last column to record any custom values you need to set.
Table 5: Factory Default Values
Category Parameter Default Value Custom Value
Unit Type Remote
MYID 1234
TOID FFFF
Active Channel 1
Rx Frequency on Active Channel 464.5500 MHz
Radio
Tx Frequency on Active Channel 464.5500 MHz
Baud Rate 9600
Data Bits 8
Stop Bits 1
Transmit Character Timeout 100
Transmit Character Timeout None
DCD Mode Disabled
Pre-Data DCD Time 500 msec
Post-Data DCD Time 500 msec
Serial
Diagnostic Programming Mode Disabled
Maximum Packet Size 300
Packet Mode Enhanced Telem
Data Rate 12000 bps
ACKs Disabled
Data
Contention CSMA
Trigger MYID
ID 0000
Transmit Channel 1
Repeater
Entry
Transmit Delay (ms) 0