User guide

REAR VIEW

The Rear Panel consists of a MAIN POWER and CONTROL CABLE connector, TO

RECEIVER and TO MOUNT F-Connectors. The Nomad SD Controller differs from the

Nomad SD2 in that the SD Memory Card Slot is located in the rear of the unit between the

Control Connector (9 pin) and the “To Receiver” F-type connector.

CONNECTIONS

12 VDC: Provides +/- 12 volt DC input power for Controller and

Mount operation.

Control Cable: Sends +/- 12 volt DC power to the Mount motors and

receives positioning information from the dish.

To Receiver: This cable routes the TV signal to the Satellite Receiver (see the label on

the bottom of the Controller.)

To Mount: This cable routes to the Roof Mount to provide LNB power (see the label on

the bottom of the Controller.)

NOTE: For DirecTV 5 LNB Slim Line High Definition receivers that require a

B-Band Converter (BBC), install it before the Controller.

For Dish Network receivers that use a Separator, install it after the

controller.

12 VDC Control Cable To Receiver To Mount