Installation guide

Mount Installation Guide
5
DEFINITIONS
The mount consists of several components that make it up.
DISH, REFLECTOR, PARABOLA
Receives signal from the satellite and reflects it into the LNB.
LNBF
Receives the focused signal from the dish and blocks the noise from the signal and sends it to the satellite
receiver by way of the coax, hence, it is called a Low Noise Blocker (Feed).
vGPS
Virtual Ground Positioning System is used to calculate Elevation and Skew when required by the system.
LNB ARM
Holds the LNB in the proper focal point of the Dish.
DISH SUPPORT ARMS
Attaches the dish and skew assembly to the Base Unit.
SUPPORT ARM ATTACHMENT BOLTS
Securing bolts that secure the Dish Support Arms to the Base Unit.
BASE UNIT
Performs the rotating functions in both Azimuth and Elevation. It is attached to the roof of the RV by screws
or bolts.
Dish, Reflector, Parabola
LNBF
LNB Arm
Dish/Skew Support Arms
Base Unit
Dish Support Arms
Attachment Bolts
LNB size will vary in
configuration depending
upon service requirements.
vGPS will be mounted here