Owner`s manual

WAVECOM

Sr. owner’s manual 18

Connecting Receiver to Remote TV through VCR

This setup enables you to record transmitted audio and video on your remote

VCR and also enjoy the picture and sound on a remote TV.

Step 1. Make sure the WAVECOM

Sr. ON/OFF switch is in the OFF position.

Connect one set of audio/video (A/V) cables to the A/V jacks of the

receiver and to the jacks on your VCR labeled LINE IN. Be sure the

yellow, red and white plugs match the yellow, red and white jacks on both

the WAVECOM

Sr. receiver and the VCR. If the VCR has only a single

jack for audio input, connect the white plug to it.

Step 2. If your TV has A/V input jacks, connect another set of A/V cables to the

TV’s A/V jacks and to the jacks on your VCR labeled LINE OUT.

Step 3. If your TV has only a single coaxial input port, connect a length of coaxial

cable from the TV’s VHF/UHF IN coaxial connector to the OUT coaxial

connector on your VCR. To watch cable channels on the TV, connect

your cable TV hookup to the IN coaxial connector on your VCR.

Step 4. Plug one end of the provided power adapter into the back of the

WAVECOM

Sr. receiver and the other end into any 120-volt wall outlet.

Turn the ON/OFF switch to ON position and indicator light should go on.

Step 5. Locate and orient the WAVECOM

Sr. receiver according to the chapter

of this manual titled “Orienting Units for Optimal Performance.”