Owner`s manual

WAVECOM
TM
Sr. owner’s manual 12
How to transmit audio/video from an audio/video
(A/V) receiver
Since most audio/video (A/V) receivers have multiple input and output ports, you can
easily transmit signals from several audio/video or audio-only components to a
remote location using WAVECOM
TM
Sr.. To transmit from your A/V receiver,
follow the instructions below.
Step 1. Use audio/video (A/V) cables to connect the LINE OUT ports on any of
the components you wish to enjoy in another location to the AUDIO IN
and VIDEO IN ports on the back of your A/V receiver.
Step 2. Make sure the WAVECOM
TM
Sr. ON/OFF switch is in the OFF position.
Connect one set of audio/video (A/V) cables to the A/V jacks of the
transmitter and to the AUDIO/VIDEO OUT jacks of the A/V receiver, Be
sure the yellow, red and white plugs match the yellow, red and white jacks
on both the A/V receiver and the transmitter.
Step 3. Plug one end of the provided power adapter into the back of the
WAVECOM
TM
Sr. transmitter and the other end into any 120-volt wall
outlet. Turn the ON/OFF switch to ON position and indicator light should
be go on.
Step 4. Locate and orient the transmitter according to the chapter of this manual
titled “Orienting Units for Optimal Performance.”
Step 5. To transmit audio/video from a particular component connected to the A/V
receiver, select that component to be the output from the A/V receiver.
Consult the owner’s manual of your A/V receiver for further instructions.