To the Users of WAVECOMTM Sr. Important safety precautions w To prevent fire or shock hazard, do not expose this product to rain or moisture. Do not use near a bath tub, wash bowl, sink, or laundry tub; do not use in a wet basement or in or around a swimming pool. w To avoid electrical shock, do not open the case of this product. w Operate this product using only the power supply included with it or provided as an accessory.
Table of Contents CHAPTER 1. INTRODUCING........................................................................... 1 P RODUCT OVERVIEW .............................................................................................1 LIST OF P ACKAGED CONTENTS...............................................................................2 CONTROLS AND FEATURES.....................................................................................3 CONTROLS AND FEATURES.............................................
Chapter 1. Introducing Product Overview WAVECOM TM Sr. uses the latest in wireless communication technology to deliver consistently sharp stereo audio and color video images up to 300 feet (FCC approved version) and 750 feet (BZT approved version) away. By transmitting at a very high frequency (2.4 GHz or 2.4 billion cycles per second), the WAVECOM TM Sr. avoid the crowded 900 MHz band used by many cordless telephones and other wireless audio/video transmitters.
List of Packaged Contents The following elements should be included in the box. Please check that you have them all before installation. 1. One transmitter (Transmitter) Transm its 2.4 GHz wireless audio/video and receives UHF remote control signal from the receiver. 2. One receiver (Receiver) Receives 2.4GHz wireless audio/video and transmits UHF remote control signal back to the transmitter. 3. Two audio/video (A/V) cables Connect transmitter and receiver to your audio/video components.
Controls and Features Transmitter Front View Directional 2.4 GHz antenna Transmits and receives audio and video signals. Remote control antenna Receives UHF remote control signals. Caution: Do not rotate this antenna 360 degrees or permanent damage to both antenna and mechanical stopper will occur. Indicator light The indicator light should be lit when the On/Off switch is at On position. Remote control window Infrared passes through this to remotely control audio/video signal source.
Controls and Features Transmitter Front View Directional 2.4 GHz antenna Transmits and receives audio and video signals. Caution: Do not ratate this antenna 360 degrees or permanent damage to both antenna and mechanical stopper will occur. Indicator light The indicator light should be lit when the ON/OFF switch is at ON position. Remote control window Transmits UHF remote control signals. Rear View Channel selection switch Use to find optimal reception.
Chapter 2. Setting Up Units Requirements Using absolutely no wires, WAVECOM TM Sr. can send audio or video signals from virtually any sound or picture source to any TV, video monitor or powered speakers using the same connectors as your other electronics components. To enjoy wireless video and audio, just connect the transmitter to whatever picture or sound source you want to view or hear at another location, and then connect the receiver to the TV, computer, or powered speakers in that other location.
Connecting the Transmitter How to transmit audio/video from your VCR Step 1. Make sure the WAVECOMTM Sr. ON/OFF switch is in the OFF position. Connect one set of audio/video (A/V) cables to the A/V jacks of the transmitter and to the A/V jacks on the back of your VCR labeled LINE OUT. Be sure the yellow, red and white plugs match the yellow, red and white jacks on both the VCR and the transmitter.
How to transmit audio/video from your cable TV hookup To transmit your cable TV channels, you must have either a VCR or a cable converter box. If you use a VCR, follow the instructions on the previous page for transmitting from your VCR. To use your cable converter box, follow the instruction below. Step 1. Make sure the WAVECOMTM Sr. ON/OFF switch is in the OFF position.
How to transmit audio/video from your satellite receiver or laser disc player You can transmit audio/video either directly from your satellite receiver or laser disc player, or by connecting them to your VCR. To transmit directly from your satellite receiver or laser disc player, follow the instructions below. Step 1. Make sure the WAVECOMTM Sr. ON/OFF switch is in the OFF position.
How to transmit audio/video from your camcorder In conjunction with a camcorder, WAVECOM TM Sr. becomes a portable wireless security system. First, position the camcorder so that it views the scene you wish to monitor, such as a sleeping baby, children at play, the elderly, or the infirm. Then, follow the instructions below. Step 1. Make sure the WAVECOM TM Sr. ON/OFF switch is in the OFF position.
10 WAVECOMTM Sr.
How to transmit audio/video from a miniature CCD camera In conjunction with a miniature CCD camera (sold separately - see accessories), WAVECOMTM Sr. becomes a portable wireless security system. First, fasten the CCD camera to any object using its clip adapter so that it views the scene you wish to monitor, such as a sleeping baby, children at play, the elderly, or the infirm. Then, follow the instructions below. Step 1.
How to transmit audio/video from an audio/video (A/V) receiver Since most audio/video (A/V) receivers have multiple input and output ports, you can easily transmit signals from several audio/video or audio-only components to a remote location using WAVECOMTM Sr.. To transmit from your A/V receiver, follow the instructions below. Step 1.
How to transmit audio from your stereo receiver To enjoy sound from your CD player, cassette deck or radio on speakers in another room, you can connect WAVECOMTM Sr. to your stereo receiver. To use this feature, you must connect either powered speakers or another amplifier to the WAVECOMTM Sr. receiver at the remote site (see “Connecting the Receiver”). Step 1. Make sure the WAVECOMTM Sr. ON/OFF switch is in the OFF position.
How to transmit audio from your CD player or cassette deck Your can transmit audio either directly from your CD player or cassette deck, or you can connect them to your stereo receiver. For either scenario, to enjoy audio on remote speakers, you must connect either powered speakers or an amplifier to the WAVECOMTM Sr. receiver at the remote site (see “Connecting the Receiver”). Step 1. Make sure the WAVECOMTM Sr. ON/OFF switch is in the OFF position.
How to transmit audio/video from your computer WAVECOMTM Sr. can send computer images and sounds to any TV in the home or office using a sound card and a VGA-to-TV Converter (purchase both at your local computer store). You also need a mini st ereo phono plug-to-stereo RCA adapter (purchase at your local electronics store). This feature allows you to send presentations from your desktop or laptop computer to a large TV screen without running wires between the two.
jack on the back of the transmitter. The red and white audio plugs are not used. Step 4. Plug the mini stereo plug of the RCA adapter into your the card, and the red and white A/V plugs into the AUDIO LEFT and AUDIO RIGHT jacks on the back of the transmitter. Step 5. Plug one end of the provided power adapter into the back of the WAVECOMTM Sr. transmitter and the other end into any 120-volt wall outlet. Turn the ON/OFF switch to ON position and indicator light should go on. Step 6.
position. If your TV has A/V jacks, connect one set of A/V cables to the TV’s A/V jacks and to the A/V jacks on the receiver. Be sure the yellow, red and white plugs match the yellow, red and white jacks on both the TV and the receiver. If the TV has only a single jack for audio input, connect the white plug to that jack. Step 2. Follow Steps 4 and 5 on the following page. WAVECOMTM Sr.
Connecting Receiver to Remote TV through VCR This setup enables you to record transmitted audio and video on your remote VCR and also enjoy the picture and sound on a remote TV. Step 1. Make sure the WAVECOMTM Sr. ON/OFF switch is in the OFF position. Connect one set of audio/video (A/V) cables to the A/V jacks of the receiver and to the jacks on your VCR labeled LINE IN. Be sure the yellow, red and white plugs match the yellow, red and white jacks on both the WAVECOMTM Sr. receiver and the VCR.
How to receive audio on your remote powered speakers Since WAVECOM TM Sr. only receive stereo signals and does not amplify them, the speakers you use to enjoy wireless sound must be self-powered or attached to an amplifier or stereo receiver. To use self-powered speakers, such as computer speakers, follow the instructions below. Step 1. Obtain a mini stereo phono jack-to-stereo RCA adapter at your local electronics store. Make sure the WAVECOMTM Sr. ON/OFF switch is in the OFF position.
How to receive audio on any remote speakers You can enjoy wireless sound without using powered speakers as long as you use an amplifier or stereo receiver to boost the signal from the WAVECOMTM Sr. receiver. This feature allows you to listen to a multiple-CD changer or other audio source on a stereo in another room. Step 1. Make sure the WAVECOMTM Sr. ON/OFF switch is in the OFF position.
How to receive audio/video from your computer WAVECOM TM Sr. can be used to receive TV broadcasts on a computer monitor in the home or office using a TV/Video Card (purchase at your local computer store) . This feature allows you to transmit live TV broadcasts from your large TV screen to a desktop or laptop computer without running wires between the two. Step 1. First, insert the TV/Video Card into one of your computer’s open slots, preferably one which is close to the VGA controller.
making sure to match the color code of the RCA plugs and jacks. Step 4. Plug one end of the provided power adapter into the back of the WAVECOMTM Sr. receiver and the other end into any 120-volt wall outlet. Turn the ON/OFF switch to ON position and indicator light should go on. Step 5. Locate and orient the transmitter according to the chapter of this manual titled “Orienting units for optimal performance.” Orienting units for optimal performance WAVECOMTM Sr.
Warning: See instructions shown below for rotating audio/video antenna. Rotating antenna beyond the specified range will result in permanent damage to both antenna and mechanical stopper. In most situations, the flat pitted face of the A/V antennas on both the transmitter and receiver should be facing one another. Since each home is different, for optimal reception, additional slight pivots or rotations may be necessary.
Orienting the Remote Control Antennas For most applications, the transmit remote control antenna should also be oriented vertically with respect to the main housing (see diagrams 1 & 2) Remote Control Antenna 2 Pitted Side Audio/Video Antenna Audio/Video Antenna Audio/Video Antenna 1 Pitted Side Remote Control Antenna Pitted Side Audio/Video Antenna Transmitter (Front View) Receiver (Front View) Pitted Side Transmitter (Front View) face Receiver (Front View) If you remoter remote control exten
Using the Remote Control Feature WAVECOMTM Sr. not only allows you to send crisp audio/video from one area to another, it also gives you the ability to control the source using your existing remote control device. The infrared (IR) signal at the WAVECOMTM Sr. receiver and then sends it back to the WAVECOMTM Sr. receiver and then sends it back to the WAVECOMTM Sr.
RF Remote Control Signal 2.4 GHz Audio/Video Signal 1 Receiver TV 4 Transmitter TV IR Extender Mouse Remote Control Other Audio/Video Components 3 IR Sensor IR Signal 26 WAVECOMTM Sr.
Chapter 3. Troubleshooting Problems and solutions Please read this owner’s manual carefully and follow the steps described in it. If you still have difficulties, consult the following table. It will guide you through the most common problems and their solutions. Problem No picture or sound. Possible solutions w Check the power on/off switches on the transmitter and receiver. w Check power switches on the remote TV and video source. (VCR, laser disc player, satellite receiver, etc.
Specifications Transmitter n Output Level 94 dB microvolts/meter at 3 meters n Operating Frequency Band 2.4 to 2.4835 GHz ISM band n Modulation FM (video and audio) n Video Input Level 1V p-p n Audio Input Level 1V p-p n Video Input Impedance 75Ω n Audio Input Impedance 600Ω n Power Supply 12 Vdc, 500 mA n Dimensions 6.0 x 4.5 x 1.
EC DECLARATION OF CONFORMITY For the following equipment: Product Name: WAVECOM-III Senior is herewith confirmed to comply with the requirements set out in the Council Directive on the Approximation of the Laws of the Member States relating to Electromagnetic compatibility directive (89/336/EEC) and Low Voltage Directive (73/23/EEC).
Other Products by RF-Link WAVECOMTM Jr. A 2.4 GHz wireless audio/video sender. Sends high quality color picture and stereo sound between rooms through walls, floors and ceilings. Comes without remote control capabilities. WAVECOMTM Sr. A 2.4 GHz wireless audio/video sender. Sends high quality color picture and stereo sound between rooms through walls, floors and ceilings. Comes with remote control capabilities.