Specifications

FCC warning：
1. This device should be installed and operated with minimum distance 20cm
between the radiator&your body.
2. This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
3. Changes or modifications not expressly approved by the party responsible
for compliance could void the
user's authority to operate the equipment.
4. This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
5. The devices must be installed and used in strict accordance with the
manufacturer's instructions as described in the user documentation that comes
with the product.
Any company of the host device which install this modular should perform
the test of radiated emission and spurious emission according to FCC part
15C : 15.247 15.407 and 15.209 requirement, and the module should comply with
the KDB file 996369 Module approval, Only if the test result comply with these
requirement，
then the host can be sold legally.
6. During operation, the separation distance between user and the a
ntenna shall be
at least 20cm.
7. The host product shall be properly labelled to identify the modules within the
host product. The FCC certification label of a module shall be clearly visible at all
times when installed in the host product; otherwise, the host product must be
labelled to display the FCC certification number for the
module, preceded by the word "contains" or similar wording expressing the same
meaning, as follows:
Contains FCC ID: 2AGQ3-8821
In this case, 2AGQ3-8821 is the module's certification number.
8. This device is intended only for OEM integrators under the following conditions:
1)The antenna must be installed such that 20 cm is maintained between the
antenna and users, and
2)The transmitter module may not be co-located with any other transmitter or
antenna.
9.