RF-Link 2.
Package Content Camera x 1 Monitor x 1 Power Adapters x 2 Battery for Monitor ( 3.7V 1000mAH Li-ion ) x 1 User's Manual x 1 Figures and Quick Guide Product Layout Monitor (Fig. 1) 1. LCD screen 2. Antenna 3. VOX: Voice Operated Transmission button 4. Power indicator LED 5. Link indicator LED 6. Volume indicator LEDs 7. Speaker 8. VOX (Voice Operated Transmission) indicator LEDs 9. Brightness adjustment buttons 10. Power / Volume control 11. Power adapter socket 12. Battery compartment 13.
Camera (Fig. 2) 1. Antenna 2. Power indicator LED 3. Infrared LEDs 4. Lens 5. Supporting stand 6. Night-light button 7. Night-light 8. Microphone 9. Battery compartment 10. Power ON / OFF switch 11.
Set Up Camera Setup 1.1 Power Supply Loading the Batteries (See Fig. 3) 1. Loosen the screw on the bottom of the camera by using a screw driver. (Step 1) 2. Open the battery compartment cover. (Step 2) 3. Insert 4 AAA-size batteries (follow the plus (+) and minus (-) signs inside the battery compartment). (Step 3) Note : The camera uses either 4 AAA batteries (alkaline battery recommended) or AC power current. 4. Close the battery compartment cover, and make sure it is locked securely.
1.2 Fine Tuning (See Fig. 5) Place the camera in a convenient location, point the lens towards the observation area and adjust the angle by rotating the lens head. 1.3 Night light (See Fig. 6) Press the night light button, the night light LEDs will remain ON.
1.4 Night vision The camera has nine high-intensity LEDs for picking up clear images in the dark. When the built-in photo sensor detects low ambient light levels, the LEDs will automatically activate. Monitor Setup 2.1 Power Supply Loading the Battery (See Fig.7) 1. Open the battery compartment cover on the rear of the monitor. (Step 1) 2. Insert the battery and make sure the polarity is correct. (Step 2) Note: The monitor uses 3.7V 1000mAH (Li-ion) battery or the household AC power. 4.
Note 3: "OUT OF RANGE" would be displayed on the LCD screen if the monitor is exceeds the range. (See Fig. 9) 2.2 Brightness Setting (See Fig. 10) Adjust the Brightness selection button / to adjust brightness. 2.3 VOX (voice-operated transmission) Function (See Fig. 11) 1. Press the "VOX" button of the monitor. This will turn off the screen but the "VOX" LED will remain ON (blue). 2. When the sound from the camera reaches the set level, the screen will turn on automatically.
Troubleshooting You don't get a signal at all • Make sure the camera and the monitor are turned on. • Make sure the power plugs are pushed all the way in. • If the camera/monitor is powered by batteries, replace all batteries with new ones. If the signal is poor, or there is interference • If there is a microwave oven in use in the path between the camera and monitor, remove the microwave oven or turn it off.
• Do not attempt to open the case. Non-expert handling of the device may damage the system. • Avoid dropping or strong shocks. • Operate this product using only with the power supply included or provided as an accessory. • Do not overload electrical outlets or extension cords this can result in fire or electric shocks. • Do remember that you are using public airwaves when you use the system and that sound and video may be broadcast to other 2.4 GHz receiving devices.
