User Manual

9
CHAPTER 3
DRIVER INSTALLATION FOR WINDOWS
The following section will assist you to in installing wireless LAN Adapter
successfully. You will first install software (Utility) and then insert / attach the
Wireless LAN Adapter to your system, and finally set the network properties to
accommodate resource sharing and select the type of wireless network that you
wish to install. The Wireless LAN card can easily be installed and used, without
bothering to connect cables for keeping your computer to use network resources.
3.1. Installation Overview
Here are some steps you will perform in establishing your wireless network
connection:
l Install the software using the Install CD.
l Install the Wireless LAN Card (WIRELESS LAN 11Mbps Adapter).
l Install the network protocol(s) required to communicate on your
network. Most likely you will need the TCP/IP protocol.
3.2. Install Procedure for Windows
98/ME/2000/XP
Note: Do not insert the WLAN Adapter until you are asked to do so, failure of
which may result in unsuccessful installation of your WLAN device.
Please follow the following steps one by one in order to install the WLAN
Adapter successfully.
1. Power on your computer and allow Windows 98/ME/2000 to load fully.
2. Be sure that there is no Wireless LAN 11Mbps Adapter inserted yet.
3. Insert the given Installation CD in the CD-ROM and then click on the
Setup.