User's Manual

©2015 RF IDeas
Configuration Utility User Manual
P a g e | 54
Image 69: Define
Fields
Functions Descriptions
Define Fields
Click to select the number of source bits to define the fields. The correct type must be
selected to allow for all card bits to be manipulated.
Check to enable the highlighted field. This allows the delimiters to be output and the
Enable
corresponding card field to be processed and output. All green fields are enabled. All
red fields are disabled.
Keyboard
Click to select key delimiters that are stored in the device’s flash memory that precede
card data output.
Clear Click to clear keystrokes preceding the card data.
Decimal Click to display the card field in decimal format.
Hex Click to display the card field as a base 16 number in uppercase HEX 09 and AF.
Displays the card data in binary coded decimal, where each 5 bits represent 1, 2, 4, 8,
BCD/Parity
Octal
and parity. FASCN data is always odd parity. It’s a mutually exclusive display mode. No
other conversion is applicable afterwards.
Enables Octal output for the selected field. Its not a mutually exclusive display mode,
so Wiegand and Hashing key conversion will also be applicable. The Octal mode is
available for pcProx Plus reader with extended feature only.
Invert Bits Invert bits. Zero becomes 1 and One becomes 0.
Reverse Bits Reverse the bits from the card.
Reverse Bytes
Reverse the Wiegand data bytes from the card. The settings on the Extended tab
perform the same functionality as the Data Format tab in Standard mode. The Reverse
bytes, Reverse bits, and the Invert bits are disabled and greyed out when the pcProx
readers with extended feature in octal mode.
Hashing Key
Selects hashing key to use for encrypting the selected field. The Hashing Key selection
box allows the user to select the key they wish to use for encrypting the selected field.
The options are “Off, “A” or “B”. The Hashing key is only available to pcProx and
pcProx Plus readers with extended feature and operating in extended mode.