User's Manual

INT R/W Verify or Set the trailing character count

(0 to 3) u

CHAR R/W Verify or set end of line termination character

( A - Z, 0 - 9, a - z or ASCII \0x00 ….\0x0D)

CHAR R/W Verify or set separating character between the facil-

ity code and ID data( A - Z, 0 - 9, a - z or ASCII \0x00

….\0x0D) Ex: 123 ; 456789

CHAR R/W 1st character sent when card is removed

( A - Z, 0 - 9, a - z or ASCII \0x00 ….\0x0D)

CHAR R/W 2nd character sent when card is removed

( A - Z, 0 - 9, a - z or ASCII \0x00 ….\0x0D)

BOOL R/W IF True, enable echo of user input and use of backspace

key

BOOL R/W IF True, enable RF IDeas command prompt

INT (hex) R/W Verify or set the logical unique identifier as 16 bit INT

(0x0000..0xFFFF)

Function Read the device part number

Function Read firmware version (major . minor . variant)

BOOL R/W IF True, use 64 bit math on ID data

BOOL R/W IF True, use 64 bit math on facility code data

INT R/W Verify or set Length of facility code output

(up to 25 digits)

BOOL R/W IF True, enable facility code output as hex

BOOL R/W Enable output of facility code

BOOL R/W Set to True to separate ID and FAC. False processes ID

and FAC together.

BOOL R/W IF True, hex ID data is output in lowercase

BOOL R/W Verify or Set ID data length (0 to 25 digits) Note: If

value is shorter than actual Id length the left most

significant digits will be truncated

BOOL R/W IF True, enable ID data output as hex

Function View menu of commands, summary of output types

and variable options

BOOL R/W Beeper output control True=beep, False=silent

BOOL R/W Continuous read mode True=continuous

output, False=single output of credential data

BOOL R/W IF True, enable Quiet mode. (IE: Credential data is not

displayed) Note: data can still be retrieved using

function rfid:qid.

INT R/W

LED output control 0=off, 1=red, 2=green, 3=Amber

(Immediate out w\o write)

255=Automatic control by reader (requires write to

flash) red on standby, green when credential is read

Chapter 4 ASCII Command Protocol