Manualshelf

User's Manual

ManualsBrandsRF Controls ManualsElectronicsRFID Signal Acquisition & Source Locationt ITCS102
12345678910
SASL Installation Guide V1.11 - Part # ITCS-A-100-001v1.11 May 2009
7
ELECTRICAL INSTALLATION
Electrical installation requires the connection of two plugs.
AC Mains Input
AC mains input is provided on an IEC connector on the power supply module as shown in figure 5.
Connect the provided IEC mains cord to the power supply and plug it in to a suitable mains outlet.
Note that the mains outlet must be located in close proximity to the SASL and must be accessible
to enable easy disconnection of the mains supply to the SASL in case of emergency or when
servicing.
Ethernet
The Ethernet LAN connection uses the industry standard RJ-45 connector. A suitable Ethernet
cable fitted with an RJ-45 plug is connected to the SASL RAID processor box as shown in figure 5.
The SASL is factory programmed with a fixed IP address which is shown on the label adjacent to
the Ethernet connector.
Figure 5
ITCS-A-100 Power and Ethernet Connections