User's Manual

SASL Installation Guide V1.11 - Part # ITCS-A-100-001v1.11 May 2009
2
Introduction
This SASL™ User Guide provides the basic information needed to install and set up an individual
SASL antenna unit. This guide is not intended to provide instructions for installing, configuring and
calibrating the RF Controls Intelligent Tracking and Control System (ITCS™). Detailed instructions
are provided in the Technical Manual (ITCS-A-100-002) and Programmer’s Reference Guide
(ITCS-A-100-003).
INTENDED AUDIENCE
This guide is intended for those who will install and set up the RF Controls SASL (Signal
Acquisition and Source Location) unit. Before attempting to install, configure and operate this
product, you should be familiar with the following:
• Windows based software installation and operation
• Device communication parameters including Ethernet and serial communications
• RFID reader configuration including antenna placement and RF Parameters
• Electrical and RF safety procedures.
CONTENTS
1. SASL overview
2. Installation
3. Software
4. Specifications
5. Safety instructions
FCC NOTICE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
CONTACT INFORMATION
RF Controls, LLC
1141 S. 7
th
Street
St. Louis
MO 63104-3623
USA
Phone: [phone] Fax: [phone]
e-mail: [e-mail] Web site: http://www.rfctrls.com