User's Manual

SASL Installation Guide V1.11 - Part # ITCS-A-100-001v1.11 May 2009

Software

The SASL is provided with a basic test program on a CD, to run on a Microsoft™ Windows

equipped Personal Computer. The program enables you to carry out a number of basic tests:

• Command the SASL to transmit

• Adjust the RF output power of the SASL as a percentage of maximum power. (Note: the

maximum output power is factory set to the maximum RF output power allowed for the

particular country of destination).

• Identify a tag by its UII (Unique Item Identifier) ISO18000-6C tag or EPC (Electronic Product

Code) in the case of an EPC UHF Gen 2 tag.

• Display the Received Signal Strength of each tag

• Display the Phi Φ and Theta θ values of the SASL beam direction.

The installation software should automatically install when the CD is inserted into the PC. If for any

reason it does not auto run, then browse for the setup.exe file on the installation CD and run it.

Once the program has been successfully installed it may be opened.

Figure 7 shows the basic test program control panel screen.

Figure 9

Test Program Control Panel Screen