User's Manual

SASL Installation Guide V0.9 - Part # ITCS-A-100-001v0.92
6
ELECTRICAL INSTALLATION
Electrical installation requires the connection of two plugs.
AC Mains Input
AC mains input is provided on an IEC connector on the power supply module as shown in figure 5.
Connect the provided IEC mains cord to the power supply and plug it in to a suitable mains outlet.
Note that the mains outlet must be located in close proximity to the SASL and must be accessible
to enable easy disconnection of the mains supply to the SASL in case of emergency or when
servicing.
Ethernet
The Ethernet LAN connection uses the industry standard RJ-45 connector. A suitable Ethernet
cable fitted with an RJ-45 plug is connected to the SASL RAID processor box as shown in figure 5.
The SASL is factory programmed with a fixed IP address which is shown on the label adjacent to
the Ethernet connector.
Figure 5
Power and Ethernet Connections
WARNING
The interconnect wiring and cables on the rear of the SASL are factory installed and are not
intended to be field serviceable. The RF cables are specially tuned. Any tampering or
modification of these cables or connections will invalidate type approval and may seriously
compromise the device performance. Note that the connectors are fitted with tamper evident
seals.