User's Manual

SASL Installation Guide V0.9 - Part # ITCS-A-100-001v0.93
10
Specifications
General
Frequency UHF band: 860 – 960 MHz *Note
RF Radiated Output Power Adjustable from 0.1 to 4 Watts EiRP
Regulatory Compliance FCC, CFR47 Part 15.247
Reading/writing Protocols ISO18000-6C / EPC UHF Gen 2
EM 4122 (TTO)
FCC ID WFQITCSA100
Application Interface ISO/IEC 24730
Environmental
Operating Temperature 0 to 60 deg C
Storage Temperature -40 to 85 deg C
Relative Humidity 5 to 95% non-condensing
Dimensions 64in x 32in x 6in (162.5 x 81.25 x 15.24 cm)
Weight 75 lbs (34 kg)
Ethernet LAN
Connector RJ-45
Ethernet 10/100 BaseT
Indicators Yellow – link operational
Green – network traffic detected
Signals Pin 1 TXD+
Pin 2 TXD -
Pin 3 RXD+
Pin 4 NC
Pin 5 NC
Pin 6 RXD -
Pin 7 NC
Pin 8 NC
Power Supply
Input Connector IEC/EN 60320
Voltage 90 – 265 Volts AC
Frequency 48 – 62 Hz
Consumption 90VA
Antenna
Gain Nominally 8.6dBi (depends on transmit frequency)
Polarization Circular
Note:
The SASL uses the Sirit INfinity 510 RFID reader which is type approved for use in the USA, Canada,
Europe and many other countries. The specific operating frequency/s and transmit mode will be factory
set at time of shipping, to suit the country of installation and use.