User Guide

SASL Installation Guide V2.13 - Part # ITCS-A-100-001v1.13 Sept 2012
6
ELECTRICAL INSTALLATION
Electrical installation requires the connection of two plugs:
AC Mains Input
AC mains input is an IEC connector as shown in figure 3. Connect the provided IEC mains cord to
the power supply and plug it in to a suitable mains outlet. Note that the mains outlet must be located
in close proximity to the SASL and must be accessible to enable easy disconnection of the mains
supply to the SASL in case of emergency or when servicing. The form and location of the AC mains
input is the same on the ITCS-A-200 and ITCS-A-202.
Ethernet
The Ethernet LAN connection uses the industry standard RJ-45 connector. A suitable Ethernet
cable fitted with an RJ-45 plug is connected to the SASL Array Controller box as shown in figure 3.
The SASL is factory programmed with a fixed IP address which is shown on the label adjacent to
the Ethernet connector. The form and location of the Ethernet connection Input is the same on the
ITCS-A-200 and ITCS-A-202.
Figure 3
ITCS-A-200 and ITCS-A-202 Power and Ethernet Connections are similar in form and location.