User Guide
Manuals
Brands
RF Controls Manuals
Electronics
RF ID Interrogator
91
92
93
94
95
96
97
98
99
100
Table Of Contents
Reader Overview
Reader Hardware
Reader Software
Transitioning from the INfinity 510 to INfinity 610
Reader Equipment Installation
Mechanical Installation
Electrical Installation
Reader Startup Tool (RST) Software Installation
Installing RST Software
Windows 7 Setup
Reader Startup
Initial Reader Setup
Reader Operation
Basic Operation with RST
Deployed Reader Operation with RCT
Reader Startup Tool (RST)
View Readers on the Network
Configure Reader with the Setup Wizard
Customize Discovery Options
View or Change the Reader’s Network Settings
Reader Test Tool (RTT)
Reader Diagnostics Tool (RDT)
Embedded Reader Configuration Tool (RCT)
Basic Configuration
Advanced Functions
Expert Configuration
User Application Management
Change Operating Mode
View Tags
Check Reader Status
Review Logs
Configuring Digital Inputs and Outputs
Digital Inputs
Digital Outputs
Low Latency Digital Input/Output Operation
Digital I/O Monitoring and Control Scripts
Digital Input Alarm Generation
Digital I/O Hardware Connection
Specifications
Safety Instructions
Power Disconnect Device
RF Safety
Electrostatic Discharge
Regulatory Compliance
Appendix B
IN610 DIO Interface Module
88
IN
finity
610
User’s Guide
13
Once the installation is complete, press
Finish
.
14
Open the Device Manager and ve
rify the driver was installed correctly as
shown in the following:
1
...
...
94
95
96
97
98
...
...
112
