User's Manual

Active RFID Tags: Features, Specifications, and Deployment Guidelines

Mounting R110 and R114-i Flex-Mount Tags

To mount R110 and R114-I Flex Mount Tags, use one of the following two methods:

A. Remove the adhesive backing liner and apply the adhesive side down to the surface of the asset.

B. Alternatively, for a flexible mounting option, slide a zip-tie through the slot on the top of the tag and then

through an opening on the asset to be tracked. Then, close the zip tie and trim the tail of it, if necessary.

NOTE: R114-i tags should be installed with the lens side facing equipment (label side out), with the tie wrap inserted

through the tag hole that is positioned furthest from the IR lens. (i.e.; tags lens positioned towards bottom).

NOTE: R114-i tags should be installed with the tag placed at the same distance or plane in reference to the IR strips

installed for use with the A740 Rack Locator. Optimal rack configurations will have tag mounted where there

is a slight bend downward when attached to the asset.

NOTE: R114-i tags should be installed on an asset where the tag is located, at least three inches away from the IR

strip or side of the rack. This will allow the tag to receive a maximum coverage from multiple IR LEDs. It will

also help to prevent the asset tags themselves from blocking a significant amount of any IR LED’s

transmission coverage.