User Manual

Active RFID Tags User Guide 2

Trademarks

RF Code

and the RF Code logo are trademarks of RF Code, Inc. All other product names are copyright and regis-

tered trademarks or trade names of their respective owners.

Information in this document is provided solely to enable system and software implementors to use RF Code

products. There are no express or implied copyright licenses granted hereunder to design or fabricate any integrated

circuits or integrated circuits based on the information in this document.

RF Code reserves the right to make changes without further notice to any products herein. RF Code makes no war-

ranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does RF

Code assume any liability arising out of the application or use of any product, and specically disclaims any and all

liability, including without limitation consequential or incidental damages.

The user of this system is cautioned that any changes or modications to this system, not expressly approved by RF

Code, Inc., could void the warranty.

This document, as well as the hardware and rmware described therein, are furnished under license and may only be

used or copied in accordance with the terms of such license. The information in these pages are furnished for infor-

mational use only, are subject to change without notice, and should not be construed as a commitment by RF Code,

Inc. RF Code assumes no responsibility or liability for any errors or inaccuracies that may appear in these pages.

Every effort has been made to supply complete and accurate information. However, RF Code assumes no responsi-

bility for its use, or for any infringements of patents or other rights of third parties, which would result.

RF Code, Inc.

9229 Waterford Centre Blvd.

Suite 500

Austin, TX 78758

www.rfcode.com

FCC Compliance

The system is designed to operate with RF Code Active RFID Tags – Whose operating frequency is 433.92 MHz

which have been certied or are in the certication process. These devices comply with part 15 of the FCC rules.

Operation is subject to the following two conditions:

(1) these devices may not cause harmful interference, and

(2) these devices must accept any interference received, including interference that may cause undesired operation.

a. FCC ID: P6F2005433 for standard products.

b. FCC ID: P6F433MHZ for safety and security products.

c. FCC ID: P6FX for M174 products.

d. FCC ID: P6FY for M180 products.

Preface