User's Manual
Table Of Contents
- User Manual
- Contents
- 1 – Introduction
- 2 – Hardware
- Front View – LED Indicators
- Rear View – Data Connections
- Antennas – Positioning
- Environmental Limits
- Tag Positioning
- 3 – Firmware
- File System
- Upgradeable Firmware
- Reader Setup
- Configuration Files & Default Settings
- 4 – Troubleshooting
- A – List of Acronyms
- B – Index
- C – FCC Compliance
© Copyright 2003 RF Code, Inc. All rights reserved. UM-C2020-R02-20030422.
No copying of this material is allowed without prior written permission. Page 12 of 27.
USER MANUAL – Mantis™ II 433.92MHz Reader
12
Reader Setup
Figure 3.1 – Network-enabled Reader Programmer Utility.
To perform a Reader setup or update:
Step 1 – Launch the Configure Mantis II Reader utility, found in the RF
Code Mantis II Reader program group on the Start Menu. (The location
will be different if the defaults were not used during the install process.)
Step 2 – The Network-enabled Reader Programmer utility appears in a
DOS screen (see Figure 3.1 above). Refer to the commands below:
• Reader Settings – Refer to page 13.
• Network Settings – Refer to page 14.
• Advanced Network Settings – Refer to page 15.
• Programming Options – Refer to page 16.
• Network Installation – Refer to the example on page 17.