Technical data

0803UDSA-2GBEN, Pag. 26/36
6. Remove burner
a) Locate the burner body front support. Remove
the screws that attach it to the secondary air
shield. Refer to fig. 14 for component defini-
tions.
b) Holding the venturi tube, slide the entire burner
slightly to the right to disengage the burner from
the supports on the left. Then rotate the open end
of the venturi tube outward away from the heater.
Carefully pull the burner assembly out of the cabi-
net.
Figure 14 - Burner removal
steps
Figure 13a
2. Remove screws attaching burner
3. Venturi tube : slide right, rotate outward, pull
out
1. Disconnect manifold at orifice and
outside the heater, slide to the right
Figure 13b