Operator's Manual

Memory Scan

The Memory Scan function is very similar to the Search function, except

it only scans those frequencies stored in the memory channels. To Scan

the memory channels, press the Recall Key to enter the Recall function.

Then press and hold the Up or Down Key for one second to initiate either

an upward or downward Scan. The word SCAN will appear on the screen

and the memory channel number and frequency will be displayed on the

top line of the screen.

When a broadcasting signal is found, the word SCAN will ﬂash and the

PJ2 COM will stop temporarily on that frequency. If the broadcasting

signal is cut off for more than two seconds, the Scan will resume until

another signal is found.

The Scan may be canceled at any time by pressing the Clear Key. The

direction of the Scan may also be reversed at any time by pressing and

holding the Up or Down Key (whichever is appropriate) for one second.

Once you have pressed the Clear Key to exit a Scan, you are still in the

Recall function. Press the Clear Key again to exit the Recall function. The

PJ2 COM will remain on the last frequency received.

It is very important that the Squelch be properly adjusted prior to

initiating a Scan. The background static received with the squelch off may

be strong enough to disrupt a Scan. If a Scan gets “stuck” on a frequency

with too much background noise, increase the Squelch or press and hold

the Up or Down Key for one second to skip that frequency and resume

Scanning. Please note, since ATIS broadcasts continually, a Scan will

always stop on an ATIS frequency if it is included in the Scan.

Manual.indd 19 8/9/19 5:46 PM