Operator's Manual

14
Operating Instructions
To perform the following functions you must be in the basic operating
mode of the PJ2 COM. To ensure that you are in the basic operating
mode, press the clear key until the last frequency that was entered
manually is displayed.
Manual Frequency Selection
The PJ2 COM will receive and transmit on the 760 COMM frequencies
(118.000 MHz to 136.975 MHz). The frequency currently selected is
always displayed at the top of the PJ2 COM’s screen and the last frequency
is always underneath the current frequency.
From the example above, the PJ2 COM is receiving 122.975 MHz with the
last frequency being 121.000 MHz. To manually enter a desired frequency
such as 118.700 MHz, enter 1 1 8 7 0 0 using the numeric keypad. As each
digit is entered, the flashing cursor moves to the next digit. Six digits may
be required to select a frequency.
The PJ2 COM will return to the previous frequency if there is a pause of
five seconds between key entries while entering a new frequency. The
Clear Key may be pressed at any time prior to entering the sixth digit to
clear the digits entered and return to the previous frequency.
Any frequency outside of the range listed above will not be accepted. The
PJ2 COM will beep when such a digit is entered. For example, starting any
frequency selection with a number other than 1 or attempting to place a
5, 6, 7, 8 or 9 in the second digit will result in a beep.
The PJ2 COM can flip flop between the current frequency and the last
requency by pressing the button above the PTT on the side of the radio.
Manual.indd 14 8/9/19 5:46 PM