User's Manual
Re-connection
Each Wireless Speaker Microphone is uniquely con-
nected to a specic mobile charger. This ensures that
all communications between the two units are secure
and cannot be compromised or interfered with by a
third party. In the event of a Wireless Speaker Micro-
phone being lost, it can be permanently disconnected
from the mobile charger by connecting with a new re-
placement unit.
How to re-connect: hold the speaker mic while pressing
both the blue up and down volume controls until the
blue LED ashes and the speaker mic beeps.(About 8 secs.)
Press together
until LED ashes
and unit beeps
Now place the speaker mic back
into the mobile charger. After a few
seconds the speaker mic will sound
a conrmation two tone and the
blue LED on both units will glow solid
to indicate connection is complete.
Microphone adjustment
The Wireless Speaker Microphone
system is usually factory set for stand-
ard audio levels required to provide
satisfactory mobile radio transmit
voice levels. Should the volume be
too soft or loud and distorted, it may
require re-adjustment to set the cor-
rect level for your installation.
Using a radio systems analyser to monitor the radio
channel adjust the internal trim pot so as to achieve
maximum permitted voice deviation within minimum
voice clipping (distortion). See photo for access point
Qualied service personnel only!
12