User Manual

1514
Inserting a memory card
1. If the device is powered on, press and hold the POWER
button to power down.
2. Insert the card in the orientation shown.
3. Push the card into the slot, listening for a click sound
signaling the card is securely inserted.
Removing the Memory Card
Before removing a memory card from your V3, you must rst
dismount it for safe removal.
With the device powered down, press down the memory
card until you hear a click. Gently remove your nger (or other
pressing object) to allow the spring release to push the memory
card out of the slot.
Do not remove the memory card while the device is
transferring or accessing information. Doing so can result
in data loss or corruption or damage to the memory card or
device. Rexing is not responsible for losses that result from the
use of damaged memory cards, including the loss of data.
Step 3: Formating a Memory Card
Step 3.1: Powering the Camera
You must always connect the V3 to a power source while
operating the camera. Connect the camera to your vehicle via
the included car charger cable. Connect the larger end of the
car charger cable to your car’s cigarette lighter (12V DC power
outlet), and connect the other Mini-USB end to the Mini-USB
port on the device.
Connecting the charger improperly may cause serious
damage to the device. Any damage caused by misuse is
not covered by the warranty. Use only Rexing-approved
chargers. Using unapproved chargers or cables can damage
the device.